Cast Magic® Casting System is an easy way to add an endless variety of bright metallic, glitter and color effects to your castings. Castings are durable and UV / weather resistant. Ideal for making signs, displays, special effects, etc. Also good for reproducing sculpture and adding different effects to models and prototypes.
Save time and labor with the Cast Magic® System. You can create spectacular effects in a matter of minutes vs. hours or days of hand tooling and finishing. And, from one rubber mold, you can make one casting or many....that's Cast Magic®!
Cast Magic® Bronzonker powder is brushed into a Rebound® 25 silicone mold with Plasti-Paste® support shell. Equinox® silicone mold putty was used to quickly create plugs for eye sockets and nostrils.
Thoroughly apply the Cast Magic® Bronzonker to the mold surface paying close attention to deep detail and the side walls of the mold cavity.
Equal amount of Foam-iT!® 5 are measured by volume.
Foam iT!® 5 rigid foam is tinted with So-Strong® Brown.
Cast Magic® Bronzonker powder and Foam-iT!® 5 Part A are added to Part B.
Thoroughly mix all components scraping the sides and bottom of the container several times.
The mixture is poured into the Rebound® 25 silicone mold.
Ease Release® 2831 is applied to a backing board with several vent holes then strapped over the mold to provide back pressure.
Allow a minimum of 30 minutes cure time, then remove the backing board.
The Plasti-Paste® II support shell is removed.
Then the Rebound® 25 silicone rubber mold is removed.
Cast Magic® Bronzonker produces a finished piece in a matter of minutes.
Foam-iT!® 5 with Cast Magic® Goldfinger.
Foam-iT!® 5 with Cast Magic® Pearly Blue.