1 - Cast Magic® Bronzonker powder is brushed into a Rebound® 25 silicone mold with Plasti-Paste® support shell. Equinox® silicone mold putty was used to quickly create plugs for eye sockets and nostrils.
|
2 - Thoroughly apply the Cast Magic® Bronzonker to the mold surface paying close attention to deep detail and the side walls of the mold cavity.
|
3 - Equal amount of Foam-iT!® 5 are measured by volume.
|
4 - Foam iT!® 5 rigid foam is tinted with So-Strong® Brown.
|
5 - Cast Magic® Bronzonker powder and Foam-iT!® 5 Part A are added to Part B.
|
6 - Thoroughly mix all components scraping the sides and bottom of the container several times.
|
7 - The mixture is poured into the Rebound® 25 silicone mold.
|
8 - Ease Release® 2831 is applied to a backing board with several vent holes then strapped over the mold to provide back pressure.
|
9 - Allow a minimum of 30 minutes cure time, then remove the backing board.
|
10 - The Plasti-Paste® II support shell is removed.
|
11 - Then the Rebound® 25 silicone rubber mold is removed.
|
12 - Cast Magic® Bronzonker produces a finished piece in a matter of minutes.
|
