1 - Remove the black cap from the air filler valve.

2 - Use the tip of black cap end to depress valve core until ALL of the air escapes.

3 - Loosen and remove the hex filler cap after all the air has been let out of the container.

4 - Using a funnel, fill the Kwikee® sprayer NO MORE THAN 2/3 FULL (32 oz. / 946 ml. maximum liquid capacity) with release agent or sealing agent. Make sure the liquid you put into the sprayer is clean and free of foreign particles.

5 - Replace the hex filler cap and tighten with a wrench.

6 - Charge the sprayer with compressed air by holding a standard air chuck on the valve stem of the filler cap. Hold the air chuck on the filler cap until you hear the line pressure equalize with the sprayer.

7 - Working pressure is 80 - 120 psi. At least 80 psi. is needed to spray the full 32 oz. without a recharge of air. The maximum pressure should not exceed 200 psi. The Kwikee® sprayer is now ready to use.

8 - The Kwikee® sprayer can apply release agent to a large surface area very fast.